Hello, when transferring using the built-in migration function in HAOS from one pendrive to another, the boot files did not transfer. I had the entire system installed on a Lenovo laptop. Everything had been working for 3 months, but I started to run out of space, so yesterday evening I took a larger pendrive, connected it and started this migration/transfer process. A few minutes later the system started, in the settings in Home Assistant I saw that there was more space so I thought everything had worked out. Today when I restarted HAOS, it started redirecting me to the rescue mode or the Home Assistant emergency system (I don't know what it's called), I only have a console, I don't have any graphic panel. My diagnosis is that the boot files did not transfer, because when I disconnect the old pendrive, I don't see the supposedly new one in the BIOS at all. And when I connect the old one and disconnect the new one, the BIOS sees my pendrive but after a while it doesn't go anywhere else. When I have both pendrives connected, I get to the state I am in. What should I do now? Is it possible to somehow install these startup elements? Is it possible to somehow start this home assistant from these two pendrives so that I could make a copy and upload it again? I don't want to lose these devices and all the automations that I have. Best regards
#HAOS Rescue modeSafe-MODE AFTER MIGRATION OF DATA TO THE SECOND PENDRIVE
rotund pulsar
ancient sleet
the boot files did not transfer
It's called a data disk for a reason. You are now dependent on both. I don't like this feature.
Why are you using a pendrive at all? They are known for dying/corrupting at least as frequently as SD Cards, probably more.
I don't want to lose ... devices ... automations ...
Don't you have a backup? Because I'd recommend you flash HAOS on a proper storage device and restore it.