Aqara Z1 Pro as Zigbee Repeater | Home Assistant | Page 1

brisk orchid Jan 15, 2025, 2:06 PM

#

Hello All,

Has anyone else had luck getting a Aqara Z1 Pro to show up as a Repeater with Zigbee2MQTT? I hoped it would since it can be wired with neutral but it's showing up as an EndDevice.

Also, would it be possible at all to program the buttons to act as a momentary switch instead of a toggle? I imagine since L1 circuit can be through automation - wouldn't it be possible to configure a button press to close the circuit temporary like a momentary switch instead of keeping the circuit closed.

First foray into home automation so apologies if I'm using the wrong terminology.

Thanks,

Screen_Shot_2025-01-15_at_9.41.33_PM.png

green quest Jan 15, 2025, 2:14 PM

#

The device reports itself as an end device because that's what it is

brisk orchid Jan 15, 2025, 2:43 PM

#

I assumed their switches w/ Neutral would also be a repeater. I see their H1 switches w/ Neutral listed as a repeater (https://www.aqara.com/en/product/smart-wall-switch-h1-triple-rocker-with-neutral/). Also, the occasional reddit posts of people commenting that Z1 w/ Neutral was a repeater as well.

Wondering if there was something I did incorrectly on my end.

green quest Jan 15, 2025, 2:49 PM

#

You can't influence that at all

#Aqara Z1 Pro as Zigbee Repeater