Sonoff eWeLink SNZB-03P Stuck in detected | Home Assistant | Page 1

fair cypress Jan 13, 2025, 11:48 PM

#

I'm trying to figure out why I can't get eWeLink SNZB-03Ps to work with Home Assitant Yellow with Zigbee HA to work correctly. I have multiple units that get stuck in the "motion detected" state. Occupancy clears. If I reset to the state to "off" it will get stuck again as soon as there is any motion. I've tried resetting. (LQI 104 RSST -74) Thanks for any ideas

high eagle Jan 15, 2025, 2:33 PM

#

This device isn't fully supported yet, I have started last week to integrate this into ZHA. I currently posted a custom "quirk" over here: https://github.com/zigpy/zha-device-handlers/issues/3188 and users are reporting that this works for them.

Motion detection isn't supported in this device, so with the custom quirk this sensor is removed.

GitHub

[Device Support Request] SONOFF SNZB-03P · Issue #3188 · zigpy/zha-...

Problem description Motion is always stuck in detected Dim and bright is not reported Solution description Make motion work properly, add the dim and bright values Device signature Device signature...

fair cypress Jan 15, 2025, 7:30 PM

#

Thank you BillyBlaze!! Is motion detection as possibility in the future?

high eagle Jan 15, 2025, 10:18 PM

#

You're welcome and I have no idea, that is a question the manufacturer could answer

#

This was also the reason I went to buy an Aqara P1 😅

fair cypress Jan 16, 2025, 4:39 PM

#

LOL - HA

#Sonoff eWeLink SNZB-03P Stuck in detected