How to trigger calibration of Aqara Radiator Thermostat E1 in HA? | Home Assistant | Page 1

kindred jungle Jan 7, 2025, 9:50 PM

#

How can I trigger the calibration of an Aqara Radiator Thermostat E1 in HA?
I see "Valve detection" which is boolean, but I could not find out what it means.
Also I found "Calibrated" which is read only.

final schooner Jan 7, 2025, 9:53 PM

#

I don't think there is a calibration function for it using ZHA. I know there is one in Zigbee2MQTT

kindred jungle Jan 7, 2025, 9:55 PM

#

OK Thank you. It seems I have to switch to Zigbee2MQTT then. I just started with ZHA, because I read that it would be far more complicate to setup in Zigbee2MQTT

final schooner Jan 7, 2025, 9:55 PM

#

It's not really, lots of people use it so there's plenty of resources out there 🙂

kindred jungle Jan 7, 2025, 9:56 PM

#

Is there a website, where I can look up which feature of my device is supported in each of these protocols?

final schooner Jan 7, 2025, 9:57 PM

#

Not really, this site shows which platforms support each device: https://zigbee.blakadder.com/Aqara_SRTS-A01.html

#

And on the Zigbee2MQTT devices page you can see what is exposed for each device: https://www.zigbee2mqtt.io/devices/SRTS-A01.html

#How to trigger calibration of Aqara Radiator Thermostat E1 in HA?