#zbdongle-e as Thread Border Router

1 messages · Page 1 of 1 (latest)

lyric spire
#

hey folks, i'm having a hard time finding a specific guide for the ZBDongle-E + Thread for HAOS. I'm running on x86 and have that all running just fine (nuc) but the dongle is flashed with the latest firmware (https://github.com/darkxst/silabs-firmware-builder/blob/main/firmware_builds/zbdonglee/ot-rcp-v2.4.5.0-zbdonglee-460800.gbl)

The only issue I have now is all the guides seem to point to the skyconnect or ZB-1 and not specifically for the dongle-e. Any help pointing me in the right direction would be super appreciated as I somehow can't seem to find this

GitHub
silabs-firmware-builder/firmware_builds/zbdonglee/ot-rcp-v2.4.5.0-z...

Silicon Labs firmware builder. Contribute to darkxst/silabs-firmware-builder development by creating an account on GitHub.

hexed rock
#

If you already have the firmware flashed, then it should be straightforwards. Plug the device into USB, then in HAOS, install the OpenThread Border Router add-on and configure it with the correct USB serial port device and baud rate.