Hi all, I just bought a Home Assistant Yellow with a Raspberry Pi CM5 and tried to set it up. However when I plug the device into ethernet, put in the USB (tried both 2.0 and 3.0) flashed with the HA Yellow Installer using Raspberry Pi Manager, and power on the device, it briefly flashes the red LED one time and then continues to a solid green LED. Nothing seems to change afterward, just the solid green LED. I also tried using rpiboot to flash it directly without using the USB, but it gives the same result. I'm kind of stuck and also can't find any cases here on elsewhere on the internet that exactly show this same LED pattern. I'm new to this type of hardware, is there anyone who could help me out?
#Home Assistant Yellow CM5 has only solid green LED
shrewd dune
harsh knot
Connect a keyboard and monitor and see what it displays.
shrewd dune
No output unfortunately
limpid saffron
The USB method is not supported with a CM5. It cannot boot from a USB2 port.
https://www.home-assistant.io/blog/2024/11/27/home-assistant-yellow-gets-cm5-support/#installing-on-cm5
shrewd dune
Yeah eventually saw that too, but the I tried the suggested alternative method and it gives the same result
limpid saffron
Make sure the CM5 is fully seated in both sockets and try the HAOS image for Yellow from GitHub instead of the installer (that might not be CM5 compatible yet).
https://github.com/home-assistant/operating-system/releases/download/14.0/haos_yellow-14.0.img.xz