sharp slate
I’ve created a few Zigbee groups, each with about a dozen devices in them. Today I wanted to add a device to one of them, so I went to the group, scrolled down to “Add devices,” picked the ones I wanted, and then clicked “ADD DEVICES” at the bottom of the page. That link then goes gray and then…absolutely nothing happens. There’s no save button or anything. When I leave and go back in, the devices are not added to the group.
I’m using ZHA
gray swan
Are the devices powered on?
sharp slate
Are the devices powered on?
Yes all of them and they’re all mains devices
gray swan
Can you enable ZHA debug logging, click the button again, and disable it to generate a log?
sharp slate
Can you enable ZHA debug logging, click the button again, and disable it to gene...
Uhh... Now I don't know what to do. I enabled debug logging, then went into the group but the two devices I tried adding earlier weren't even listed AT ALL. Not in the included devices or the Add devices list...
gray swan
Are you on mobile? Or desktop?
sharp slate
I was doing it all on desktop earlier but I'm on mobile now
gray swan
There may be a bug on mobile with rendering those tables 🤔
timber basalt
That was fixed several releases back…
Put ZHA in debug mode… try again and even if the screens don’t have what you need disable debug mode and zip up the downloaded log and attach it here please.
sharp slate
Just an update: I got back to the office and checked, and now those devices showed up in “Add devices” section again. This time when I added them they appeared in the group. I have no idea what changed, since I hadn’t touched the entire system since posting this question. I had tried restarting the entire device but nothing was fixing it. It just sort of…started working all of a sudden…