Devolo MT02647 Settings Z-Wave | Home Assistant | Page 1

midnight brook Sep 20, 2024, 9:12 AM

#

#

Hello everybody,

I can’t configure the Devolo MT02647. It’s working for detection but never back to idle state. I tried a lot of settings but nothing works. Can someone help me?

#

My actual settings

#

Never goes back to Idle, no OFF sended

#

Cheers

#

Should go back to this settings:

upbeat bridge Sep 20, 2024, 10:12 AM

#

I've read that the device has a test mode, which it is in as long as the tamper switch on the back is NOT pressed. In test mode, it doesn't send motion idle.
Could that be the case?

upbeat bridge Sep 20, 2024, 10:35 AM

#

Alternatively: Set parameter 7 to 22, then look under disabled entities (there should be another motion sensor entity), enable that and disable your current one.

midnight brook Sep 20, 2024, 11:40 AM

#

I just tested it and seems to work. Disabled the original motion detection and activated the sensor state and it works. THX a lot for your help @upbeat bridge 👍

#Devolo MT02647 Settings Z-Wave