#I am having issues getting my Raspberry

1 messages · Page 1 of 1 (latest)

whole zephyr
#

So, to sum it up, my steps:

  1. Took Micro SD-card and installed the bootloader USB Boot via Raspberry Pi Imager.
  2. Inserted the SD-card into my RPi4.
  3. Connected it to the power.
  4. Waited a couple of seconds until it started blinking green, according to documentation it was succesful.
  5. Disconnected the power (pulling the cord) from the RPi.
  6. Removed the SD-card.
  7. Took a SSD, using a USB -> SSD-adapter, and used Raspberry Pi Imager to install HomeAssistant OS.
  8. Plugged in the USB/SSD into the Pi, plugged in the power.
  9. The Pi gives a code with 1 long, 1 short (see video). It does not show up in the router (when it's connected with ethernet cable), which it did when having RPi OS on the Micro SD-card.
  10. Cried.