Then you flashed the right firmware | Home Assistant | Page 1

#

i got following errors:

If problem persists, check connection and baud rate.
>Failed to create device object.```

#

i opend the serial port and it said everything is fine

This is a debug log
This is an info log
This is critical
An error occurred

COM3 - Silicon Labs CP210x USB to UART Bridge (COM3)
Select the serial port (just enter the number of the serial port):3
>>>>>>>>>>>>>>>> COM3 is opened.....
<queue.Queue object at 0x000002A1A2FE31F0>
<queue.Queue object at 0x000002A1A2FE2EC0>
Write  processing...
Write  processing...
Read processing...
Log Print processing...
>>>>>>>>>>>>>>>> end```

#Then you flashed the right firmware