#Pressing the soft reset presence sensor

1 messages · Page 1 of 1 (latest)

novel garnet
#

I'm having this same issue, but only in the last week or two. At first I thought it was picking up my PC's fans somehow as I recently updated it, but I've moved it to a place where the PC isn't visible and I'm having the same issue

#

I can use the reset_nopresence_status option to fix it, but it kinda defeats the purpose if the device doesn't detect non-presence

tawny parcel
#

Glad to hear its not just me!

@tawdry thunder I have a live situation with one of my sensors now. It picked me up entering the bathroom for my shower, and presence was detected 44 mins ago.

I can see in the logbook the Away event was triggered 21 minutes ago, but the device never cleared.

Device Type: EndDevice
LQI: 255
RSSI: -55
Last Seen: 2023-01-06T09:22:49 (5 minutes ago)
Power Source: Mains
Quirk: zhaquirks.xiaomi.aqara.motion_ac01.AqaraLumiMotionAc01

So it is still reporting. I've just hit the reset button, and nothing. The last seen hasn't updated, and presence isn't being cleared

tawdry thunder
#

That last seen value updating at all?

#

I forget if LQI (link quality) of 255 is good or bad. But the RSSI (signal strength of -55 is good)

#

My LQI is 255 also. Seems like an unused value 🤷‍♂️

#

If that last seen value isn’t updating its 100% brain dead.

# 

IEEE: 54:ef:44:10:00:58:9c:56
Nwk: 0xcc7a
Device Type: EndDevice
LQI: 255
RSSI: -62
Last Seen: 2023-01-05T18:22:20
Power Source: Mains
Quirk: zhaquirks.xiaomi.aqara.motion_ac01.AqaraLumiMotionAc01```
#

Firmware: 0x00000036

tawny parcel
#

My last seen value is still updating, but my occupancy has been in detected state now for 2 hours. I've power cycled it 3 times and still won't reset

tawdry thunder
#

Weird.

Bad hardware maybe?

Some reflective surface messing with the mmWave?

tawny parcel
#

I don't think so. After entering and leaving the room it randomly started working again.

This one is in a bathroom, so wondering if it could be moisture/humidity having an effect.