#Knx Read requests

1 messages · Page 1 of 1 (latest)

river tiger
#

Hi @umbral glade 👋!
Your *_state_address have to respond to GroupValueRead telegrams from HA.
I'd first try if these GAs are readable from ETS Diagnostics GroupMonitor.

umbral glade
#

Hi, How can i check this? Im new to knx😬

river tiger
#

In ETS open the Diagnostics window -> group monitor, hit start, type the GA you want to read and hit "Read"

#

Then watch the monitor for a response

umbral glade
#

okay nice, as soon as im done with school im going to try it, Thank you

umbral glade
#

should i control the brightness in home assistant while using the group monitor and look if the brightness value shows up?

river tiger
#

Not necessarily

umbral glade
#

this is what i get

#

Time Service Flags Prio Source Address Source Name Destination Address Destination Name Rout Type DPT Info

13 12/8/2022 1:58:28.272 PM from bus Low 1.1.15 Tastsensor 3 Plus 2fach 0/1/23 W Slaapkamer 2 Spots kast 3xled 6 GroupValueWrite 3.007 dimming control $01 | Decrease, 100 %
14 12/8/2022 1:58:29.916 PM from bus Low 1.1.15 Tastsensor 3 Plus 2fach 0/1/23 W Slaapkamer 2 Spots kast 3xled 6 GroupValueWrite 3.007 dimming control $00 | Decrease, Break
15 12/8/2022 1:58:30.281 PM from bus Low 1.1.156 Dimactor viervoudig 0/3/23 W Slaapkamer 2 Spots kast 3xled 6 GroupValueWrite 5.001 percentage (0..100%) $50 | 31 %

river tiger
#

Well, that's hard to read 🥴

#

There is no read request done.

#

Input the state-GA and press "Read"

umbral glade
#

I have some lights that show the right state but these are just lights you can turn on or off and nog change the brightness