#I have a question about print in place

clever glacier · 2022-07-07T09:20:13.793Z

I have a question about print in place | adafruit | Page 1

1 messages · Page 1 of 1 (latest)

clever glacier Jul 7, 2022, 9:20 AM

Referenced article: https://hackaday.com/2019/07/06/3d-printed-buttons-printed-as-a-single-unit/

Hackaday

Donald Papp

3D Printed Buttons, Printed As A Single Unit

These nifty buttons come from [Marc Schömann], and they are intended to cover just about any kind of tact switches. The buttons, their cover, and the compliant bits that act as a spring can be 3D p…

I did some searching and can't really find any kind of updates to this project since 2019. Maybe there are newer concepts out there, and if you know of any, I would be grateful!

Also, if you know of any buttons that are written in OpenSCAD that would be truly epic.

The plungers on these buttons are round, about 3.45 mm in diameter. Maybe just printing caps for'em would be suffient, with holes in the enclosure for the buttons themselves?