#I can't box select these faces

3 messages · Page 1 of 1 (latest)

rough pilot
#

when I try to, it flips to a completely different texture since that texture is on the same cube (right side) and would technically fall under the box select IF THAT TEXTURE WAS SELECTED

how can I make it so that I can properly box select those side faces in the uv editor? tysm

soft ruinBOT
#
Welcome to the help forum!

Please make sure to read #1029373817119838218 as it may answer your question!

Once your question has been resolved, please mark the post as closed by using the </close:1163944441741049897> command.

rough pilot
#

obvi theres other ways I could select these but I don't wanna just sit down and take it from inconveniences like this