Change number of faces/sides after creating mesh | Blockbench | Page 1

dim gust May 11, 2024, 9:14 PM

#

Hey everyone, is there any way to change the number of faces/sides of a mesh after creating it? I can't seem to find it in the UI neither through searching the keybinds.

Alternatively, is there any way to show this popover again?

Thanks!

rose condorBOT May 11, 2024, 9:14 PM

#

Welcome to the help forum!

Please make sure to read #1021015331910713395 as it may answer your question!

Once your question has been resolved, please mark the post as closed by using the </close:1163944441741049897> command.

stoic prairie May 11, 2024, 9:15 PM

#

no

dim gust May 11, 2024, 9:16 PM

#

So If I mess up the face count I'll have to recreate the mesh?

stoic prairie May 11, 2024, 9:16 PM

#

afaik yup

dim gust May 11, 2024, 9:16 PM

#

that's a bummer, thanks for clarifying that though, much appreciated!

pallid fable May 11, 2024, 10:06 PM

#

dim gust that's a bummer, thanks for clarifying that though, much appreciated!

If your question is resolved run the /close command!! It helps to keep the forums clean.

dim gust May 11, 2024, 10:31 PM

#

👍

#Change number of faces/sides after creating mesh