wintry ingot
I was almost certain that I'd glued this correctly (went around the full circle and connected both ends of the rectangle bar to the same point so that it'd go all the way around) but I still have this gap and I don't really know why? I can't tell from the mesh or the glue either so if anyone knows what might be causing this and how I can fix it without redoing all of rigs in the hat I would greatly appreciate it
white fractal
you want the circle of the big one to go up to mimic the hole?
white fractal
ok the issue is that therectangle is not glued closed
what about you make a ring instead of a rectangle?
wintry ingot
I don't think I understand sorry
white fractal
ok, imagine a ring
that is grey with a red in the middle
you use that you glue the inside to the top and the outside to the bottom
wintry ingot
ah, I see
I suppose I could try that yes
is there any way I could fix it as it is now without redoing the glue or is redoing it the only way
white fractal
how is the mesh of the tectangle?
wintry ingot
how is the mesh?
white fractal
yes
wintry ingot
the mesh looks like this if that's what you mean
white fractal
ok your issue is that yo have empty space on both ends, so when you glued it, you also got that same empty space
wintry ingot
ahh, I see
