clever laurel
Hello everyone!
Had to have a fix on this model's mouth as it was too small, but when I try and import the PSD it shows in the sidebar just fine but it won't show up in the model viewing window. The mouth below in the sidebar is what was there previously and does show up.
crisp glacier
Hello everyone!
Had to have a fix on this model's mouth as it was too small, but...
Are the lips covering the pieces?
Also gums top is hidden
clever laurel
I unchecked them just now and it still isn't showing up.
There are two different gums tops, I have one of them hidden right now.
crisp glacier
Are these pieces direct replacements? Do they need to be re-meshed to show?
clever laurel
Most of these are direct replacements or were separated even further than they were before.
Before when I tried to re-mesh they wouldn't show up with the mesh lines. Now they do but the layers still aren't showing?
crisp glacier
If you go into mesh edit, and switch the view to model guide view, can you see the artmesh?
clever laurel
oh my goodness it's in the top left corner? 😭
HAHA i'm so sorry I'm super new to this I expected it to import right on top of the old but it's in the corner 😂
crisp glacier
Did you change the canvas size? Or import as png? It should just replace in the same area.
clever laurel
Come to think of it I think the artist cropped it waaay smaller than the original model art
It was in a 1x1 ratio crop instead of the size of the model canvas so I guess that's it? 🤔
crisp glacier
Yeah, that wont translate well to existing psd if thats the case. I recommend asking the artist to integrate it properly with the original psd
Otherwise you will likely have issues if you have to reimport those later
clever laurel
🫡 Thank you so much for the help. 😭