Issue with charging port 2DS

[toxic palm]

My charging port is only supplying voltage on one of the two pins, and I have no continuity (diagram key: the red and yellow circles have continuity between them (the yellow circle with the other yellow, etc.), the blue circles have no continuity between them when I test with a multimeter, and the blue circle has blue with red fluorescent material; this is the port where I have 5 volts output). If anyone knows if I absolutely have to replace the entire port, or if soldering is enough, or if there's no problem at all (but I doubt it because I have no current at the fuses and the battery connector even though the continuity is good)

I use a traduction so maybe the traduction is not good, tell me if something is not understable

Update:
the continuity for the 2 Yellows circles is good but the one withe the rés circles does’nt work, however, the charging port got mettalic part, when I test the left red circle with it, I got continuity, but when i do the same but for the right red circle, I got nothing (and nothing with the 2 reds circles)

[toxic palm]

Nvm I got tension at batterie connector, i might have a solution if Someone want’s, i test when I got new batterie