Back again 😅 I have the funnyplaying GBA SP USB C connector installed. Two of the middle pads were accidentally ripped in the process so I’ve bridged those with wire. I’ve plugged in the USB C (USB A on opposite end) but am not getting any feedback from the orange charging led when plugged in. Any advice?
#SP USB-C no power
shy glacier
light gladeBOT
Please remember to provide as much information as possible including all troubleshooting steps you have already taken. If this is a hardware issue, please provide clear in-focus images of the issue, PCB (circuit board), installation, and any soldering you have done. Help us help you, posts with insufficient information will be deleted
shy glacier
shy glacier
Not sure if this says anything, but I do get the charge LED to respond when bridging to the link cable port
willow nova
Maybe it's just my eyes, but is this bridged?
shy glacier
@willow nova it is not, I tested continuity between all pins and none of them are bridged.
