rose latch
I've seen multiple people have the same issue that the 4th trace falls out. I was wondering what the best means or approach to this would be. I know i can follow the trace to where i should and solder a wire, but was wondering is someone has already done this.
zenith stumpBOT
Please remember to provide as much information as possible including all troubleshooting steps you have already taken. If this is a hardware issue, please provide clear in-focus images of the issue, PCB (circuit board), installation, and any soldering you have done. Help us help you, posts with insufficient information will be deleted
pearl vault
grizzled rose
Once you reinstall the power switch, you can solder a jumper wire to the top end of R13 from pin 1.
pearl vault
#troubleshooting-archived message
mighty dew
Sorry to revive the thread. I atually did this but pulled all 4 off. Does anyone know if for the red dots, you can solder 2 wires from each to the single spot, or the two wires need to be bridged first? I assume you can just scrape away a little of the letter C there and wire both very close?
