soft delta
Hello everyone, I have a H&S Infinity CR Plus airbrush, today I noticed that when I press the trigger to release air it is sometimes very slow to go back to its original position (and thus continue to deliver air for a few seconds). It does improve when I increase the air pressure.
Any hints of what could cause that and how to solve it ?
Thanks !
fallen hare
is there paint in the spring assembly?
brazen dagger
make sure there is no paint in there, libe the needle and assembly. And make sure the spring is in good condition
dark osprey
Hello everyone, I have a H&S Infinity CR Plus airbrush, today I noticed that whe...
take apart whilst using guide clean everything toroughly and reaply watever lube or other sort of material is normally used for ur airbrush then reasemble
visual root
Give it a deep clean, and check the pin that controls the air flow in the base of the airbrush (where you connect the hose). A TINY bit of lube in there may help. Its probably this pin rather than the actual trigger thats sticking.
