civic jungle
My airbrush after being cleaned did not output air. I tried to remove the nozzle, when putting the nozzle in it broke. Part of the nozzle screw end is stuck in the airbrush. Can anyone give me tips on getting it out?? And why it broke in the 1st place???
half egret
The nozzle is very fragile in general, you may have overtightened it perhaps? Can you use a cocktail stick or similar to spin the stuck part out?
civic jungle
That worked thank you @half egret , I did not know I could over tighten it. I'll keep that mind for next time
half egret
I wouldn't remove the nozzle unless you absolutely have to personally
civic jungle
I wouldn't remove the nozzle unless you absolutely have to personally
I figured it needed to be cleaned, since I cleaned the whole airbrush but it was still not outputting air