#Elegoo CC2 — horizontal ridge on outer wall, not visible in GCode preview

1 messages · Page 1 of 1 (latest)

slow ferry
#

Hello, getting a weird artifact on my prints, there's a horizontal ridge/indentation that goes all the way around the outer wall at the layer where the top surface ends and the walls continue. Rest of the print looks totally fine.
The weird part is when I check the gcode in the prusa gcode viewer it looks completely normal, no artifact there, so I don't think it's a slicer thing?
I'm running an Elegoo CC2 with black PLA basic, sliced in Elegoo Slicer. Any ideas how to solve it?

PXL_20260602_123436102.jpg
unborn sorrelBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

scenic latch
#

hey, usually this is an issue with the file itself, but to just fix it on the printer what i did was switch to 0.15 layer height and then callliberate the z offset so that it squishes a bit more. i too am still learning about this printer so if this does not help i am sorry