ender 3 v2 not extruding properly | 3D Printing | Page 1

red lion Mar 4, 2026, 12:52 AM

#

I just finished cleaning out my hot end, leveled the bed, and also replaced the nozzle. When I tried to print a benchy to test it, everything came out extremely thin and stringy, barely even coming out of the print. If anyone has any advice it would be greatly appreciated!

#

foggy mulchBOT Mar 4, 2026, 2:55 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

foggy mulchBOT Mar 4, 2026, 5:20 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

red lion Mar 4, 2026, 5:20 AM

#

bump

foggy mulchBOT Mar 4, 2026, 7:25 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

vital plaza Mar 5, 2026, 12:54 PM

#

Is the bed leveled

#

and is your z offset calibrated

#ender 3 v2 not extruding properly