Kobra s1 what do I do | 3D Printing | Page 1

brave glacierBOT Dec 27, 2025, 6:10 PM

#

AI Help

It sounds like the wire connecting your hotend may have been damaged during the build plate change. I recommend contacting the manufacturer for guidance on how to fix or replace the wire to get your 3D printer up and running again.

fluid flame Dec 27, 2025, 6:11 PM

#

There does not look to be a build plate on that. That looks like a magnetic mat that a build plate would attach to.

#

Is that correct?

#

I don't know what you mean by hotend part wire, can you show a picture and explain further?

#

Heater wires? Thermistor? The entire cord that connects to the printhead

coarse crest Dec 27, 2025, 6:17 PM

#

The thermistor part to plug it in to the print head and when it was printer and I wasent in the room the build plate itself came off and started to mess up the underneath part below the build plate

fluid flame Dec 27, 2025, 6:19 PM

#

You'll have to replace that thermistor, and try and clean up the magnet pad, or just replace that too.

#

Is the build plate you used not magnetic or something.

coarse crest Dec 27, 2025, 6:19 PM

#

It was just hit it off somehow u think ANYCUBIC will replace the parts ?

fluid flame Dec 27, 2025, 6:20 PM

#

Depends, was it an anycubic plate or not?

#

If it was a third party plate they'll probably pin the blame on you.

coarse crest Dec 27, 2025, 6:21 PM

#

I’m talking about the bed part that’s scratched the magnet pad

fluid flame Dec 27, 2025, 6:21 PM

#

I'm talking about the new build plate that caused the issue.

coarse crest Dec 27, 2025, 6:21 PM

#

Oh it’s gone and it’s 3rd party

fluid flame Dec 27, 2025, 6:22 PM

#

If it was third party they could say you used a third party plate so it isn't covered under warranty.

#

And the damage is your fault.

#

You could try though.

coarse crest Dec 27, 2025, 6:22 PM

#

Well I need a nozzle part and magnet pad tho

#Kobra s1 what do I do