Matte PLA Problems | 3D Printing | Page 1

echo oracleBOT Dec 11, 2025, 11:39 PM

#

AI Help

It sounds like you may be experiencing a clog or partial clog in your nozzle. Try cleaning the nozzle with a nozzle cleaning needle to remove any debris that may be blocking the flow of filament. Additionally, try adjusting the retraction settings in your slicer software to reduce the stringing. If the issue persists, you may need to fine-tune your temperature settings for the Matte PLA filament.

coral umbra Dec 11, 2025, 11:41 PM

#

anycubic kobra, cura, Not sure if its clog i added a whole new tip and regular PLA worked just fine

pulsar widget Dec 11, 2025, 11:44 PM

#

is the filament dry

coral umbra Dec 11, 2025, 11:48 PM

#

I would guess so, had it over my heater for a few hours since i dont have a filament dryer

pulsar widget Dec 12, 2025, 1:02 AM

#

have you matched temps with the manufacturer reccomendations?

coral umbra Dec 12, 2025, 2:04 AM

#

The highest ive done it was 220, filament holder saying 190-230, so i can try higher

coral umbra Dec 12, 2025, 2:42 AM

#

Something different happened, didnt work at first again then the filament pored out was far from each other

pulsar widget Dec 12, 2025, 3:14 AM

#

sounds like you could have a clog in the heatbrake or nozzle

echo oracleBOT Dec 12, 2025, 5:14 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

coral umbra Dec 12, 2025, 6:40 AM

#

?solved

#Matte PLA Problems