need help fixing my cr-10 PLEASE atleast talk

[desert shale]

AI Help

To connect the new thermistor with the broken wire, you will need to carefully solder the new thermistor's wires to the existing wires on your CR-10. Make sure to match the positive and negative wires correctly. If you're not comfortable with soldering, it's recommended to seek assistance from someone with experience to avoid damaging the printer. Remember to turn off and unplug the printer before attempting any repair work.

WARNING: This response is AI generated and may contain errors.

[drifting badge]

we cant see much in the picture

are you trying to connect that hot end to your toolhead?

that hot end has already a thermistor and heater in it

you remove the old heater from the toolhead

this thing

and you plug the new one

and you probably have to do the same with the thermistor (the one with the white cables)

[zinc shard]

oh okay

but the thermistor

already there

is broken

can i just cut them both

and reconnect the thermistor

to the broken thermistor?

@drifting badge

[drifting badge]

dont cut anything

you can unplug them from the PCB on the toolhead side

the plugs should match