#ender 3 v2 too many issues after firmware update

1 messages · Page 1 of 1 (latest)

vague hollyBOT
#
AI Help

It sounds like you are experiencing some issues after installing the CR Touch and updating the firmware. Here are some troubleshooting steps for each of your problems:

  1. Auto homing stuck at the same coordinates:

    • Check your bed leveling settings in the firmware. Make sure the offset values are correct.
    • Ensure the physical setup of the CR Touch is correct and it can reach all points on the bed during homing.
    • Double-check your wiring connections to the CR Touch and the board.

  2. Filament being extruded from the start of the printer:

    • This could be caused by incorrect slicer settings. Check your starting G-code in the slicer software.
    • Ensure that the nozzle is not clogged, and the hotend temperature is stable.
    • Adjust the retraction settings in your slicer to prevent filament oozing.

  3. Unable to configure Z to be in negative:

    • Check your firmware settings for the Z-axis direction. You may need to invert the direction in the firmware configuration.
      ...
WARNING: This response is AI generated and may contain errors.