It seems like you have made modifications to the configuration files and start print macro related to object exclusion and processing, but the printer is still probing the whole table. Here are some steps to troubleshoot:
Double-check the modifications made in the moonraker and printer configuration files to ensure that the syntax and parameters are correct. Make sure that the "[exclude_object]" and "enabled_object_processing: true" parameters are correctly set.
Check if there are any conflicts between the settings in your slicer and the modifications you have made. Ensure that the slicer settings are not overriding the changes in the configuration files.
Verify that the start print macro is correctly configured to reflect the changes you made. It should effectively initiate the exclusion of objects and enable the new processing features.
Additionally, confirm that the G-code commands within the start print macro are functioning as intended, especially the commands r...
crystal inlet
boreal pewter