#Issue with Ender 3 Max Neo

1 messages · Page 1 of 1 (latest)

rugged depotBOT
#
AI Help

It sounds like the issue might be related to the PID tuning of the new hotend. PID tuning adjusts the control loop that regulates the temperature of the hotend to maintain a consistent temperature. Fluctuations in temperature as you described can lead to printing issues.

To PID tune your new hotend on your Max Neo, you can follow these general steps:

  1. Make sure your hotend is not clogged and the nozzle is clear.
  2. Access the PID tuning settings on your printer. This can usually be done through the printer's menu or by sending commands through a connected computer using software like Pronterface.
  3. Start the PID tuning process by sending the relevant G-code commands. The specific commands may vary depending on your printer model. You can look up the appropriate commands for your Max Neo.
  4. The printer will go through a series of temperature adjustments to calibrate the PID values for the new hotend. Once completed, the printer should be able to maintain a stable temperature du...
WARNING: This response is AI generated and may contain errors.
rugged depotBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

rugged depotBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

blissful compass
#

?solved