#realy bad blobing and nozzel is scraping the print

1 messages · Page 1 of 1 (latest)

sturdy plankBOT
#
AI Help

It sounds like you may be experiencing issues with your first layer calibration and/or bed leveling. Here are a few troubleshooting steps you can try:

  1. Make sure your bed is properly leveled. Use the BLTouch to assist in manual bed leveling or adjust your Z-offset if needed.
  2. Check your nozzle height. Ensure the correct distance between the nozzle and the bed on the first layer.
  3. Verify that your print bed is securely attached and not loose, causing it to move during printing.
  4. Adjust your initial layer settings in Cura to provide better adhesion without the nozzle scraping the print.

If these steps do not resolve the issue, additional adjustments may be needed. Feel free to provide more details if necessary for further assistance.

WARNING: This response is AI generated and may contain errors.
# 
BenchyBot

BetaCommands:
  add_printer  Adds a printer to your name.
  belt_freq    Calculates target belt frequency (Hz) for correct tension base...
  belt_tension Calculates the tension (N) in a GT belt based on the measured...
  pi           
  random_thing Find a random thing from thingiverse.
  time         Used to get the current time in a timezone.
  topic        
GCode:
  mg           Used to search Marlin Gcode Commands.
HelpForum:
  solved       
​No Category:
  help         Shows this message

Type ?help command for more info on a command.
You can also type ?help category for more info on a category.
sturdy plankBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.