Slight Layer shift/Over/Underextrusion (Poor Print Quality) | 3D Printing | Page 1

lean vectorBOT Oct 18, 2024, 11:29 PM

#

AI Help

Hello! It sounds like you've done a thorough job troubleshooting your Ender 3 V3 SE. If you're still experiencing issues, it might be worth checking the alignment of your X and Y axis, ensuring they are square and parallel. Also, make sure your nozzle is clean and not clogged, as this can sometimes cause print quality issues. If the problem persists, consider checking your slicer settings for any anomalies. Good luck!

sleek kayak Oct 18, 2024, 11:33 PM

#

Slight Layer shift/Over/Underextrusion (Poor Print Quality)

lean vectorBOT Oct 19, 2024, 1:36 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

lean vectorBOT Oct 19, 2024, 10:15 AM

#

Is your problem solved? / No longer need this channel?
You can close a help channel with ?solved when it is no longer needed.

sleek kayak Oct 19, 2024, 10:15 AM

#

?solved

#Slight Layer shift/Over/Underextrusion (Poor Print Quality)