#Filament extrusion problem

1 messages · Page 1 of 1 (latest)

final frostBOT
#
AI Help

It sounds like you may be experiencing a clog in the nozzle of your Elegoo Neptune 3 Plus. Here are a few steps you can try to troubleshoot the issue:

  1. Heat up the hotend to the recommended temperature for the filament you are using.
  2. Carefully remove the filament from the extruder. This may require manually turning the extruder gear while gently pulling on the filament.
  3. Once the filament is removed, you can try clearing the nozzle clog by using a small cleaning needle or filament cleaning tool.
  4. Heat up the hotend again and try feeding new filament through to see if the issue has been resolved.

If you are still having trouble, you may need to disassemble the hotend for a more thorough cleaning. Make sure to follow any manufacturer guidelines or tutorials for disassembling and cleaning your specific printer model.

If you are uncomfortable with performing these steps or if the issue persists, it may be helpful to reach out to Elegoo customer support for further assistance.

WARNING: This response is AI generated and may contain errors.