#anycubic cobra 2 pro: no matter what the filament i use it keeps not grabbing onto the build plate.

1 messages · Page 1 of 1 (latest)

low kestrelBOT
#
AI Help

It sounds like you are having issues with bed leveling and adhesion. Here are a few troubleshooting steps you can try:

  1. Double-check the manual bed leveling process. Make sure all four corners of the bed are at the same level, and adjust the bed to the correct height using a piece of paper as a guide.

  2. Ensure the bed is clean and that the print surface is properly prepped. You can try using adhesion aids like hairspray, glue stick, or a dedicated print surface like BuildTak or PEI sheets.

  3. Check the first layer height and make sure it is set correctly in your slicer software. You may need to adjust the Z-offset to get the proper first layer adhesion.

  4. Calibrate the extruder steps/mm to ensure the correct amount of filament is being extruded.

  5. If the issue persists, consider checking the printer's frame and gantry for any displaced or loose components that may affect print quality.

If you continue to experience issues, it may be helpful to reach out to the manufacture...

WARNING: This response is AI generated and may contain errors.
urban basin
#

i use PLA plus or PLA silk. anycubic slicer, temps are typically 65C for hotplate and 215 for Nozzle.

warped spade
#

Try increase bed temp

#

Sometimes works

urban basin
#

i will give it a shot and see

#

This keeps happening

urban basin
#

tried increasing bed temp and did not work

low kestrelBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

urban basin
#

still need help

low kestrelBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

urban basin
#

still awaiting more help

mighty grove
#

I have a 2 plus, had a similar issue, you try messing with the offset? If that doesn’t work, try a bed adhesive