I got a new printer with a sprite extruder and dual z motors and my printer is completely unusable

[ruby hazel]

AI Help

I'm sorry to hear about the issues you're facing with your Ender 3. It sounds like you may have encountered a few different issues, including a filament feeding problem and possibly resetting the printer incorrectly. Let's try to troubleshoot the problems step by step:

1. Filament Feeding Issue:

• Make sure that the filament is loaded correctly and there are no obstructions in the extruder.
• Check the tension of the extruder arm against the filament. It should be tight enough to grip the filament but not too tight to cause excessive friction.
• Ensure that the nozzle is not clogged by performing a cold pull or a nozzle cleaning.

2. Printer Reset Issue:

• Check if the printer powers on and if the screen displays any information. If not, try checking the power connections.
• If the printer appears to be bricked, you may need to consider re-flashing the firmware. Follow the manufacturer's instructions on how to do this.

If you're unsure about how to proceed, I recommend reaching ou...

WARNING: This response is AI generated and may contain errors.

[green mountain]

did you try to clean the nozzle?

sounds like a clog to me

[honest olive]

we are so far past the nozzle problem it's not even funny

my current issue, is that it won't auto home

I'll select auto home and it will make a noise and then give me a homing error prompting me to reset the printer

[ruby hazel]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.