Orca Max Volumetric Speed Calibration | 3D Printing | Page 1

grand wingBOT Jul 21, 2024, 3:09 PM

#

AI Help

To optimize your printing speed without sacrificing print quality, it's essential to find a balance between the maximum volumetric speed (MVS), line width, and layer height. You can try gradually increasing the line width and layer height while monitoring the print quality to find the ideal settings. In some slicer software, such as PrusaSlicer or Cura, you can use features like adaptive layer height or variable line width to automatically adjust settings and optimize print speed based on your chosen parameters without sacrificing quality. Experiment with these features to find the best balance for your specific print.

grand wingBOT Jul 21, 2024, 5:14 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

slate vessel Jul 21, 2024, 5:35 PM

#

Anyone?

#Orca Max Volumetric Speed Calibration