Cleaning scraps that are stuck to the bed

[sleek shuttle]

AI Help

To remove stuck filament from the bed, you can try the following methods:

1. Heat the bed to the printing temperature and gently scrape off the filament with a putty knife or razor blade. Be careful not to scratch the bed surface.
2. Use a cleaning solution such as isopropyl alcohol to soften the filament and wipe it off with a cloth.
3. If the above methods don't work, you can try using a 3D printing specific bed adhesion remover like Magigoo or a similar product.

Regarding the nozzle oozing filament before a print, this is known as "oozing" or "stringing." You can reduce this by adjusting your retraction settings in your slicer software. Increasing the retraction distance and speed can help minimize oozing between prints. Make sure your retraction settings are optimized for your printer and filament type for best results.

WARNING: This response is AI generated and may contain errors.

[clever nacelle]

Thin leftovers usually don't cause any issue

[sleek shuttle]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.