support falling over | 3D Printing | Page 1

#

Could you include more info?

To help you get the best help try to include as much information as you can such as:
• Printer make and model,
• Any Mods,
• Firmware,
• Filament material and temps,
• Slicer,
• Any recent changes,
• What have you tried so far.

Images can really help with debugging a printer! Consider adding some to your post of the print and the printer.

#

AI Help

It sounds like you may be experiencing issues with print quality and print stability. Here are some suggestions that may help improve the situation:

Check your print speed: Slowing down the print speed can sometimes help with the stability of smaller features. Try reducing the print speed for those particular sections of the print.
Increase cooling: Inadequate cooling can lead to issues with overhangs and small features. Make sure that your cooling fan is working properly and adjust the cooling settings if necessary.
Fine-tune retraction settings: Proper retraction settings can help reduce stringing and improve print quality, especially for small features. Experiment with different retraction distances and speeds to find the optimal settings for your setup.
Consider using a raft instead of a brim: If you don't want to use a brim, you could try using a raft instead. A raft can provide better adhesion for small features without making support removal to...

#support falling over