AI Help
It sounds like you are experiencing a filament jam in your 3D printer. Here are a few steps to troubleshoot and resolve the issue:
-
Check for any filament residue or clogs in the hotend and nozzle. Heat up the hotend to the recommended temperature for your filament material and try to manually push the filament through it.
-
Ensure that the PTFE tube is properly seated and cut squarely. Sometimes, improper seating of the tube can cause jams.
-
If you are still unable to clear the jam, you may need to disassemble the hotend and clean out any obstructions thoroughly.
-
Make sure that the extruder tension is set correctly to grip the filament properly without causing too much pressure.
If the issue persists, you may want to reach out to the manufacturer for further assistance as you've already replaced the extruder gears.
thorn furnace
oak crystal