AI Help
It appears that the lines on the first layer could be caused by a slight over-extrusion or a leveling issue with your bed. Here are some steps you can take to troubleshoot this:
-
Ensure that your bed is level: Make sure that your printer's bed is properly leveled. You may need to adjust the Z offset slightly to ensure that the first layer is properly adhering to the bed.
-
Check your extrusion settings: Make sure that your extrusion multiplier is set correctly in PrusaSlicer. You may need to adjust this setting to reduce the amount of filament being extruded.
-
Check the cleanliness of your bed: Make sure that your print bed is clean and free of any debris or residue that could interfere with adhesion.
-
Verify your filament diameter settings: Ensure that the filament diameter settings in PrusaSlicer match the actual diameter of your filament.
By following these steps, you should be able to improve the quality of your first layer.
hearty sage