#should i make the top part 0.1mm thinner?

1 messages · Page 1 of 1 (latest)

strong walrusBOT
#
AI Help

Yes, reducing the top part by 0.1mm may help the carbon fiber fit better. Since you're using three layers of 0.2mm carbon fiber, a 0.6mm gap could be too tight. Try adjusting the top part by 0.1mm and test the fit. Remember to measure and test before finalizing the design.

WARNING: This response is AI generated and may contain errors.
strong walrusBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

strong walrusBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.