#flash forge adventure 3c tube stuck

1 messages · Page 1 of 1 (latest)

south lavaBOT
#
AI Help

To detach the plastic filament tube, you usually need to release the tension on the filament by loosening the tension arm or lever on your 3D printer. Then you can gently pull out the filament from the tube. If you encounter any resistance or difficulty, refer to your 3D printer's manual for specific instructions.

WARNING: This response is AI generated and may contain errors.
warm flax
#

https://www.youtube.com/watch?v=qtWLFKpItz8 probably like this (push collet around the tube down. while holding down, simultaniousl< pull on the tube)

YouTube
Duncan Rogers
Push In Fittings Explained

Push in fittings are suitable for compressed air and water systems and can be used with nylon or polyurethane tube. Easy to connect and disconnect.

For further information an to view our full range of push in fitting visit us at - http://www.airlines-pneumatics.co.uk/pneumatics/fittings/6

▶ Play video
tidal perch
#

I’ve repair it now already