belt printer questions | 3D Printing | Page 1

inland pebble Jan 15, 2024, 10:55 PM

#

Made a DIY belt printer following a project I found online. Finally got it tuned up and my first layers go down fine, but printing anything higher and the nozzle appears to just rip up the print as it goes. For anyone with experience on these types of printers, any guesses on what this could be?

sonic ravenBOT Jan 16, 2024, 12:57 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

olive mountain Jan 16, 2024, 12:08 PM

#

Can you tell us more about the setup, software and configuration?

inland pebble Jan 16, 2024, 1:51 PM

#

I’m running it off of basic marlin. The z axis is the belt and the y axis is the lead screw now

#

I’m able to get a first layer down no problem, but anything higher and it fails

#

I tuned the z strps(belt) to be accurate but that still results in the nozzle getting stuck in the print

#belt printer questions