Dan's K1 - Initial Setup / Tuning | 3D Printing | Page 2

long forum Jan 30, 2024, 6:00 PM

#

lid rattles like a mofo still

#

i have some left over of that foam

#

might try lining the edge of the lid

#

i will say

#

compared from where we started

#

clever girder Jan 30, 2024, 6:02 PM

#

For sure better

long forum Jan 30, 2024, 6:02 PM

#

LOl yeah

#

i was printing stuff just fine

#

but you know, you can always do better

#

lol

#

#

#

side spool and top chain guide

#

i think i will reprint the taller versions of these, this is the 'short' version.

#

i was trying to find if there was a chain lift support

solid hearthBOT Jan 30, 2024, 8:05 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

long forum Feb 4, 2024, 5:52 PM

#

Reopening for someone

#Dan's K1 - Initial Setup / Tuning