#Printing time/speed troubleshooting

1 messages · Page 1 of 1 (latest)

fiery hawkBOT
#
AI Help

Based on the information provided, it seems that the print speeds of both Hyper PLA and FiberWood are similar in your tests, despite the intended slower speed for FiberWood. One possibility for this could be the filament settings or slicer configurations.

Here are a few troubleshooting steps you can try to optimize your print times:

  1. Double-check filament settings: Ensure that the filament diameter and extrusion multiplier are accurately set in your slicer software for both Hyper PLA and FiberWood. Incorrect settings can lead to under or over-extrusion, affecting print times.

  2. Slicer configurations: Review the print settings in your slicer software. Make sure the print speed, acceleration, and jerk values are correctly set for each filament. Additionally, check if there are any specific settings for FiberWood, such as increased retraction or slower accelerations.

  3. Retraction settings: While you mentioned the retraction distance for each filament, also verify the retraction...

WARNING: This response is AI generated and may contain errors.