#Bad Ender 3 v2 tolerance

1 messages · Page 1 of 1 (latest)

carmine stratusBOT
#
AI Help

If your printed tolerance coin has dimensions smaller than expected, there are a few things you can try to improve the accuracy of your prints:

  1. Calibrate your extruder: Make sure your extruder is properly calibrated by measuring and adjusting the steps-per-mm value for the filament. This can help ensure the correct amount of filament is being extruded.

  2. Check your filament diameter: Measure the actual diameter of your filament with a caliper, as it may vary slightly from the specified value. Update the filament diameter setting in your slicing software if necessary.

  3. Fine-tune your slicer settings: Adjust the print settings in your slicing software to optimize the dimensional accuracy. Pay attention to the nozzle size, layer height, and print speed settings. You might need to experiment to find the best combination for your specific needs.

  4. Reduce backlash and play: Check for any mechanical issues with your printer that may introduce imprecision, such as loose belts, wo...

WARNING: This response is AI generated and may contain errors.