#Lines being pulled? Sovol 06+

1 messages · Page 1 of 1 (latest)

alpine ledgeBOT
#
AI Help

Based on the description, it sounds like you are experiencing issues with layer adhesion or bed adhesion. Here are a few troubleshooting steps you can try:

  1. Check your nozzle height: Make sure the nozzle is properly leveled and at the correct distance from the bed. If it is too close or too far, it can affect adhesion. Double-check that the nozzle is at the correct height across the entire bed surface.

  2. Clean the bed: Ensure that the print bed is clean and free from any residue or oils. Use isopropyl alcohol or a similar cleaner to wipe the bed surface before each print.

  3. Improve bed adhesion: You can try using a different type of bed surface, like a specialized print surface or adding a layer of adhesive solution like hairspray or glue stick. This can help improve the adhesion between the bed and the print.

  4. Adjust print settings: Experiment with your print settings, specifically the first layer settings. You can try increasing the initial layer speed, temperature, or f...

WARNING: This response is AI generated and may contain errors.