AI Help
To change the behavior of your printer when homing the Z axis, you'll need to make adjustments in your printer's firmware configuration file. Here's what you can do:
- Open your Klipper printer configuration file (typically named "printer.cfg") in a text editor.
- Look for the homing settings section, which may be under a 'delta' or 'probe' section depending on your printer setup.
- Search for a line that controls the Z-axis homing behavior. This could be labeled as "home_z" or something similar.
- Modify this line to remove the unnecessary travel to the center. You can either remove or comment out the line altogether or change the destination position to a different location on your build plate.
- Save the changes to the configuration file and upload it to your printer.
After making these adjustments, your printer should no longer move to the center of the build plate before homing the Z-axis. Keep in mind that the exact steps may vary depending on your specific setup, so co...
pallid monolith