It sounds like you may be experiencing an issue with your automatic bed leveling. Here are a few troubleshooting steps you can try:
Ensure that the nozzle height is properly adjusted. If it's too close to the bed, it may be triggering the sensor prematurely. Make sure there is an appropriate gap between the nozzle and the bed.
Check if the bed leveling sensor is functioning correctly. Clean the sensor and make sure there is no debris or obstruction that could interfere with its operation.
Verify that the firmware of your printer is up to date. Check the manufacturer's website for any firmware updates specific to your Sovol SV06 model.
If the issue persists, consider reaching out to the manufacturer's customer support for further assistance. They may be able to provide specific guidance based on your printer model.
Remember to always follow the manufacturer's instructions and be cautious when troubleshooting any hardware issues.
obtuse marsh
drowsy valve