thermistor sensor issue | 3D Printing | Page 1

charred gyroBOT Oct 2, 2023, 9:21 PM

#

AI Help

It is possible that the issue lies with the board not reading the thermistor sensors correctly. Here are a few troubleshooting steps you can try:

Recheck the connections: Ensure that the thermistor sensors are properly connected to the board. Double-check the wiring and make sure they are securely fastened.
Verify the resistance: Use a multimeter to measure the resistance of each thermistor sensor. The resistance values should change when temperature fluctuates. If the resistance remains constant or shows unusual values, it could indicate a faulty thermistor.
Check the firmware settings: Make sure the firmware of your Creality machine is configured correctly to recognize the thermistor type you are using. Review the manufacturer's documentation or community forums to find the appropriate firmware configuration.
Test the board: If you have access to another compatible board, consider swapping it out temporarily to see if the issue persists. This would help determine i...

hollow wave Oct 2, 2023, 9:22 PM

#

The unglued white cable is the new thermistor I’ve tried it both sides and no difference

charred gyroBOT Oct 2, 2023, 10:22 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

hollow wave Oct 2, 2023, 11:58 PM

#

If anyone has any tip feel free to dm me

charred gyroBOT Oct 3, 2023, 1:02 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

hollow wave Oct 3, 2023, 2:52 AM

#

.

charred gyroBOT Oct 3, 2023, 3:52 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

hollow wave Oct 3, 2023, 10:21 AM

#

.

#thermistor sensor issue